How the figures are worked out
Skirting run. The perimeter of every room, added up, less the width of each door opening. Perimeter is 2 × (length + width) per room.
Architrave run. Per side of each opening: two legs at the door height plus 100 mm for the mitre, and one head at the door width plus 300 mm for the horns. Multiplied by the number of openings and the number of sides.
Waste. Added to both runs. Ten per cent is the default and it is low rather than high — mitres and scribes waste more than people expect.
Lengths. Each run divided by the stock length, rounded up to whole sticks.
Why the answer is in whole lengths
Because you cannot join trim wherever the arithmetic would like you to. A skirting joint has to land somewhere it can be fixed and somewhere it will not be stared at, and an offcut shorter than about a metre is firewood.
This is also why the length count can jump by two when the run only grows by a few centimetres. If that happens, look at your longest wall: a 3.1 m wall against 3.0 m stock is the single most expensive measurement in the room, and sometimes the answer is to buy one length in a longer size rather than two in the standard one.
What the perimeter misses
A width-times-length perimeter assumes a plain rectangle. Real rooms have chimney breasts, bay windows, alcoves, and returns beside the door — all of which add run, none of which the box formula sees.
Walk the room with the plan and add the extra as a separate rectangle, or measure wall by wall and enter a long thin room for the remainder. For a bay, the three faces across the front are nearly always longer than the wall they replaced.
Decide the profile before the floor goes down
Skirting height and profile are a decision that interacts with the floor: a tall Victorian skirting under a thick engineered board looks wrong, and a modern square-edge profile against an ornate cornice looks like two houses arguing. Materials, colour and finish covers how those choices hang together.
The order also matters. Skirting goes on after the floor in most builds, so the floor runs underneath and expansion gaps hide behind the trim — see the order of operations for where it sits relative to everything else.
Common questions
- How do I work out skirting for an L-shaped room?
- Split it into rectangles and enter each as its own room, then subtract the run where the two rectangles meet — that edge is not a wall. The calculator adds perimeters, so an L entered as two boxes counts one internal line twice.
- How much extra should I buy?
- One length over whatever the calculator says, as a rule. The waste allowance covers mitre and scribe losses, but it cannot know that your longest wall is 3.1 m and your stock is 3.0 m — that single wall now needs two lengths and leaves a long offcut. Check your longest walls against the stock length before ordering.
- Mitre or scribe the internal corners?
- Scribe them. Walls are never truly square, and a mitred internal corner opens up as soon as the timber moves or the house settles — a scribed joint is cut to the profile of the piece it meets and stays shut. External corners are mitred, because there is no alternative.
- Does the architrave figure include both sides of the door?
- It does by default, and you can change it to one side. A door between two finished rooms is trimmed on both faces; a door into a cupboard or an unfinished space is often trimmed on one. Each side is two legs and a head, so switching from one side to two doubles the figure.